Skip to main content

Introduction

This guide provides the steps to install the Xirgo XT-63xx on Heavy Duty vehicles with the ECMD Diagnostics cable and 3 Wire power connection

  1. Record serial number
    • Record serial number

    • You will need the serial number to link the unit to the vehicle and to verify operation. It is best to record the S/N before starting installation.

  2. Amber - Cellular Signal Solid - Ignition ON; Cellular network lock
    • Amber - Cellular Signal

    • Solid - Ignition ON; Cellular network lock

    • Flashing - Ignition OFF

    • Fast Flashing - Ignition ON; Searching for cellular network

    • Bluetooth

    • Flashing - Bluetooth connected

    • Green - GPS

    • Flashing - Satellite count +1

  3. Find a location for device to be installed.
    • Find a location for device to be installed.

    • Secure the device mechanically with Zip-ties, Velcro, ect.

    • Install the device (sticker side up) with a clear line of site out of the vehicle.

    • Device will work through glass, plastic, and most composites.

    • Do Not place directly under metal.

    • Examples

    • Behind Instrument panel.

    • "A" Pillar

  4. Plug the ECMD cable into the Xirgo device.
    • Plug the ECMD cable into the Xirgo device.

  5. Plug 24 pin I/O harness connector into the device.
    • Plug 24 pin I/O harness connector into the device.

  6. Wire colors may change, always verify the pin number. Input 1=Pin 6; (+) Positive input
    • Wire colors may change, always verify the pin number.

    • Input 1=Pin 6; (+) Positive input

    • Input 2=Pin 7; (-) Negative input

    • Picture 2

    • Garmin

    • Panic/Privacy

    • Driver ID Buzzer

    • Driver ID Reader

  7. Using the 24 pin power harness, locate and connect to Battery and Ignition sources.
    • Using the 24 pin power harness, locate and connect to Battery and Ignition sources.

    • I.E. - Ignition switch or fuse box

    • Using a ring terminal, terminate the ground wire to chassis using a self tapping screw or a factory bolt.

    • Wire colors:

    • Red = Battery

    • White = Ignition

    • Black = Ground

  8. Remove OEM DLC (Data Link Connector) (Photo 2) Plug the OEM DLC into the diagnostic Y cable included in the kit
    • Remove OEM DLC (Data Link Connector)

    • (Photo 2) Plug the OEM DLC into the diagnostic Y cable included in the kit

    • Twist to lock connection. Connection will "click" when locked.

    • Mount the diagnostic Y cable's replacement DLC connector into OEM location.

    • Secure cable along the way, staying clear of any moving parts

    • Verify operation through the Reveal Hardware installer app or call the Reveal Technician Support line to verify install at 866-908-1165

    • Download the Reveal Hardware Installer application for iOS and Android at the Apple store and Google store Apple App Store & Google Play

Conclusion

See www.verizon.com/about/privacy/fullprivacypolicy for more information.

2 other people completed this guide.

Dozuki System

Member since: 09/24/2009

60 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 5

Past 7 Days: 24

Past 30 Days: 109

All Time: 429