Skip to main content

Changes to Step #6

Edit by Eric Croucher

Edit approved by Eric Croucher

Before
After
Unchanged

Step Lines

-[title] Install 3-Wire
-[* black] Using the 24 pin power harness, locate and connect to Battery and Ignition sources
- [* icon_note] I.E. - Ignition switch or fuse box
-[* black] Using a ring terminal, terminate the ground wire to chassis using a self tapping screw or a factory bolt.
-[* icon_note] Wire colors:
+[title] Install 3-Wire Connections
+[* icon_note] Locate and connect to Battery and Ignition sources on the vehicle such as the ignition switch or fuse box ,and connect them to the corresponding I/O harness leads below.
+[* icon_reminder] Wire colors:
[* red] Red = Battery
[* violet] White = Ignition
[* black] Black = Ground
+ [* black] Use a ring terminal to terminate the ground wire to chassis using a self tapping screw or a factory bolt.