Installation guide: Driver ID

This is a printed page that might be out of date. To read the most up-to-date help content, visit https://device-help.verizonconnect.com.

Skill level: Basic

The installation can be performed quickly and easily by individuals of any ability.

Driver_ID.png

Estimated time for install: 10-15 minutes

The driver ID equipment consists of a Key Fob, a Reader, and a Buzzer, which will sound if someone starts the vehicle without using the fob.

To install driver ID, follow these steps:

  1. Find a suitable location to install the Reader, that is convenient for the driver to use and has a minimum 3/4” (19 mm) clearance depth behind where you intend to mount it.Minimum_Depth.png
  2. Drill a hole in the mounting location using a 3/8” (9.5 mm) drill bit. Drill_Bit.pngDrilled_Hole.png
  3. Remove the retaining washer from the 2-pin connector.
  4. Feed the wire from the Driver ID FOB reader through the front side of the hole. Feeding_the_Wire.png
  5. Apply gentle pressure to seat the reader. Seating_the_Reader.png
  6. Slide the washer over the connector, then up the length of the wire and over the stem of the reader to secure it against the panel. Placing_the_Washer.pngSecuring_the_Washer.png
  7. Plug the 2 pin Driver ID reader into the telematics unit harness’s 2 pin connector. Connecting_the_Reader.png
  8. Coil any excess wire from the reader and secure it using zip ties to prevent it from interfering with the driver and safe operation of the vehicle controls.
  9. Reinstall any panels that were removed during installation. Reinstalling_Panels.png

Disclaimer

Verizon Connect shall have no liability whatsoever for any damages that arise from, or are connected with, your use of our services, including GPS tracking hardware, in a manner contrary to the(se) instructions or in violation of law and/or our agreement. Installed devices may only be removed and transferred to another vehicle if the second has been tested for compatibility, as per the(se) instructions. Transfers between vehicles which do not follow the(se) instructions will void any and all warranties from Verizon Connect, and relieve Verizon Connect of all liability for damages that arise from or are connected with your use of the devices.


Was this article helpful?


0 out of 0 found this helpful